Williams Sound WIR TX8 Instalační příručka stáhnout pdf (Strana 10)

Williams Sound

Helping People Hear

FIG. 7: WALL OR CEILING MOUNT

Figure 7a: Mounting the TX10

on to a wall with the BKT 024.

Tip:

To keep the TX10 level,

rotate the tension screw (Fig. 6)

so it rests on top of the bracket.

Figure 7b: Mounting the TX10

on to a ceiling with the BKT 024.

INSTALLATION PROCEDURE

The TX10 Infrared Transmitter should not be installed outdoors, or where there is a lot of direct

sunlight indoors. Sunlight generates infrared interference. Certain types of high-efficiency lighting

fixtures can also generate interference at 95 kHz because they use high frequency modulation.

INSTALLATION STEP 1: MOUNTING THE TX10 TO A WALL OR CEILING

Step 1: Using the mounting plate (Figure 6) as a template, mark the hole locations on the mounting surface

where the TX10 will be installed. See Figure 7 below for optional mounting positions.

Step 2:

Locate the top mounting hole in the rear of the TX10 transmitter. Gently screw the male end of the swivel

head on to the transmitter. Tighten the swivel head

tension screw

: turn clockwise until the connection is

secure.

Step 3: Screw the male end of the shaft into the female end of the swivel head. An additional shaft can be

added to create more distance between the wall/ceiling and Transmitter.

Step 4: Place the plate cover snugly over the mounting plate. This will hide the screws after installation.

Step 5: Screw the male end of the mounting plate into the female end of the shaft.

For suspended ceilings,

screw

the female end of the shaft into the male end of the

T-Bar clip

. The mounting bracket is now installed on to

the TX10 Transmitter.

Step 6: Position the TX10 Transmitter and BKT 024 so the mounting plate lines up with the marked holes on the

mounting surface. Fasten the mounting plate to the surface using screws and wall anchors.

Mounting

the TX10 to a Suspended Ceiling with Cross Tee:

Fasten the T-Bar clip on to the desired Cross Tee.

Step 7: Position the TX10 Transmitter to the desired angle: Begin by gently turning the tension screw (Figure 6)

counter clockwise to release the swivel head. Adjust the TX10 to the desired angle. When the TX10 is in

the desired position, gently turn the tension screw clockwise until the swivel head is securely in place.

FIG. 6: BRACKET 024 MOUNTING

TX10 Emitter

Swivel Head

tension screw

Shaft

(optional)

Shaft Plate

Cover

Mounting

Plate

Mounting

Screws

(To Wall or Ceiling)

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 23 24

Komentáře k této Příručce

Žádné komentáře

Williams Sound WIR TX8 Instalační příručka Strana 10

Komentáře k této Příručce

Související produkty a manuály pro Přijímač Williams Sound WIR TX8