Williams Sound DLT 100 2.0 Uživatelský manuál stáhnout pdf (Strana 5)

DLT 100 2.0 Digital Transceiver and DLR 60 2.0 Digital Receiver

Getting Started: Preprogrammed Systems

If a system has been purchased, you will not need to perform any programming. The system will have been congured to your

order. Turn chairman master on rst so other units can pair. Slave units will turn o after 5 minutes if they cannot nd a

master.

1. Charge all DLT 100 2.0’s. If using DLR 60’s, either charge them with NiMH batteries or insert fresh Alkaline batteries. Make

sure the battery switch is in the correct position for “Alkaline” or “NiMH”. Any DLR 60 2.0’s that will be used should have fresh

batteries.

2. Identify and turn on the Chairman Master (CM) rst, usually identied by a grey silicone cover. Turn on the DLT by holding the

power button until the LCD screen comes on. If Chairman Slave (CS) or Slaves are powered up rst they will turn o after a few

minutes if not paired with the CM. As Chairman Slave and Slaves are paired with the CM the CM and CS will show C-#. The #

refers to how many DLT 100 2.0’s are paired within the group, i.e. C-12 means that 12 DLT 100 2.0’s are paired with the CM or

CS within their group. This can be utilized as an attendance checker making sure everyone is connected with the group.

3. Once all the DLT’s are on, you can check the set-up status of all units by pressing the power/menu button momentarily to

scroll through the settings:

Chairman Master and Chairman Slave screens will display:

C-6 (Chairman plus six = number of participants within the group).

ADD Address number (0 – 1023). Each DLT must have its own individual address.

Group number (0 – 1023) must be the same number for the group.

CODE Only shows if a code has been entered (code number will NOT be displayed).

“F-#” Denotes software version.

Time Displays the time of day. (Note: F-7 rmware version does not have Time of Day).

All Slave units will display:

Address Number

Group Number

Secure Key Code (if entered)

Software Version

Time of Day (Not available on F-7 rmware version)

4. If headsets are to be worn, plug them into the jacks on the top of the DLT’s making sure that the Microphone and Earphone

plugs are inserted into the correct jacks.

5. The Chairman Master will usually be the rst speaker and should press the talk button momentarily to activate the microphone.

This will be conrmed by the red LED around the talk button illuminated. If the talk LED is ashing, the talk button was held too

long and the talk mute has been activated in the system. Hold the talk button until the LED’s stop ashing to deactivate talk mute.

6. The Chairman Slave and all Slave units should now be hearing audio from the CM unit. Listening volume levels can be adjusted

by pressing the – or + button. One other DLT can activate the Talk button for team tour or teach applications. A maximum of

two talkers can be activated at any one time. For a Slave unit to talk, either the CM or CS will have to turn their talk button o

by quickly pressing their talk button.

1 2 3 4 5 6 7 8 9 10 ... 31 32

Žádné komentáře

Williams Sound DLT 100 2.0 Uživatelský manuál Strana 5