Williams Sound SoundPlus Infrared System WIR SYS 90V Instalační příručka stáhnout pdf (Strana 18)

Williams Sound

Helping People Hear

MOUNTING THE TX9 TO A WALL OR CEILING, STEP-BY-STEP:

Step 1: Using the mounting plate (Figure 16a) as a template, mark the hole locations on the mounting

surface where the TX9 will be installed.

Step 2: Locate the top mounting hole in the rear of the TX9 emitter. See Figure 16. Gently screw the male end

of the swivel head on to the emitter. Tighten the tension screw (Figure 18): turn clockwise until

the connection is secure.

Step 3: Screw the male end of the shaft into the female end of the swivel head. An additional shaft can be

added to create more distance between the wall/ceiling and Emitter.

Step 4: Place the plate cover snugly over the mounting plate. This will hide the screws after installation.

Step 5: Screw the male end of the mounting plate into the female end of the shaft.

For suspended ceilings,

screw the female end of the shaft into the male end of the

T-Bar clip

. The mounting bracket is now

installed on to the TX9 Emitter.

Step 6: Position the TX9 Emitter and BKT 024 so the mounting plate lines up with the marked holes on the mount-

ing surface. Fasten the mounting plate to the surface using screws and wall anchors.

Mounting the TX9

to a Suspended Ceiling with Cross Tee:

Fasten the T-Bar clip (Figure 16b) on to the desired Cross Tee.

Step 7: Position the TX9 Emitter to the desired angle: Begin by gently turning the tension screw (Figure 18)

counter clockwise to release the swivel head. Adjust the TX9 to the desired angle. When the TX9 is in the

desired position, gently turn the tension screw clockwise until the swivel head is securely in place.

The tension screw controls the action of the swivel head. To lock the swivel head into position,

turn the tension screw clockwise. To release the swivel head action, turn the tension screw counter clockwise.

swivel

head

knob

Figure 18: BKT 024

Figure 17a

Figure 17b

Figure 17a:

Mounting the TX9 on to a wall with

the BKT 024.

Tip: To keep the TX9 level, rotate

the tension screw (Fig. 18) so it rests

of top of the bracket.

Figure 17b: Mounting the TXP on to

a ceiling witth the BKT 024

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 35 36

Žádné komentáře

Williams Sound SoundPlus Infrared System WIR SYS 90V Instalační příručka Strana 18