Williams Sound SoundPlus Infrared System WIR SYS 90V Instalační příručka stáhnout pdf (Strana 9)

Williams Sound

Helping People Hear

CONFIGURATION SETTINGS

SWITCH SETTINGS

CARRIER FREQUENCY

CHANNEL A

CHANNEL ENABLE

MIX INPUTS

MICROPHONE SIMPLEX POWER

MIC/LINE INPUT

COMPRESSOR GAIN

AUTO SHUT-OFF TIMER

2 CHANNEL/STEREO

DO NOT SET BOTH CHANNELS

TO THE SAME FREQUENCY

TURNS CHANNEL OFF WHEN

DISABLED

15 VOLTS PER DIN 45596

LINE ALWAYS ON 1/4 INCH

MIC OR LINE ON 3 PIN

SETS MAXIMUM AVAILABLE

COMPRESSOR GAIN

TURNS CARRIER(S) OFF AFTER 30

MINUTES OF NO AUDIO

NOT AVAILABLE IN

LINE INPUT MODE

IN STEREO MODE, CHANNEL A

COMPRESSION SETTING

CONTROLS BOTH CHANNELS

AVAILABLE ONLY IN ONE

CHANNEL OPERATION

12345678

ENABLED

NOT MIXED

NON-STEREO

OFF

LINE

MAXIMUM

MODERATE

DISABLED

ENABLED

MIC

STEREO

MIXED

DISABLED

CHANNEL B

12345678

2.800 MHz

3.300 MHz

3.800 MHz

2.300 MHz

Arrow down

indicates

off

position

Arrow up

indicates

position

CH A & CH B

Configuration Switches

Configuration

Switches

Input CH A Input CH B

CH A

CH B

Made in USA

12345678

Figure 7

Adjust switch settings on rear of

MOD 232 Modulator here:

CARRIER FREQUENCY

Choose between four selectable frequencies: 2.3, 2.8, 3.3, or 3.8

MHz. Select one frequency for each channel. MAKE SURE EACH

CHANNEL

IS SET TO A DIFFERENT FREQUENCY. To operate in four-

channel mode, two MOD 232 units will need to be installed (see

Figure 4, page 6).

To select a frequency on the MOD 232:

Instructions:

For 2.3 MHz: Place switch 4 & 5 in the “off” position.

For 2.8 MHz: Place switch 4 in the “on” position,

Place switch 5 in the “off” position.

For 3.3 MHz: Place switch 4 in the “off” position,

Place switch 5 in the “on” position.

For 3.8 MHz: Place switch 4 in the “on” position,

Place switch 5 in the “on” position.

The diagram below (Figure 7) illustrates how to configure your system using the configuration

switches (Figure 8) on the back of the MOD 232 Modulator. This diagram is also printed on top of

the MOD 232 Modulator unit for quick reference.

Figure 8: Configuration Switches

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 35 36

Komentáře k této Příručce

Žádné komentáře

Williams Sound SoundPlus Infrared System WIR SYS 90V Instalační příručka Strana 9

Komentáře k této Příručce

Související produkty a manuály pro Přijímač Williams Sound SoundPlus Infrared System WIR SYS 90V